Welcome to aurora.com! Log in or Sign up to interact with the aurora community.

Bulldog Lite Nema Wiring

Discussion in 'Bulldog Extruder' started by Gordon Gekko, May 20, 2014.

  1. Gordon Gekko

    Gordon Gekko New Member

    Joined:
    Jan 18, 2014
    Anyone have the wiring diagram for the Nema 17 that ships with the Bulldog Lite? Mine has Red, Green, Black and Blue wires.

    I've seen the other thread with this configuration listed, but I was hoping to get some confirmation from someone at RepRapD. I just want to make sure I don't mess anything up at this point.

    Thanks,

    -GG
     
  2. David

    David New Member

    Joined:
    Jan 29, 2013
    The wire colours will be shown on your electronics board pdf file.. I use both Rumba´s and Azteeg X5´s.
    Or search the RepRap.org forum ?
     

Share This Page