Welcome to aurora.com! Log in or Sign up to interact with the aurora community.

Bulldog XL and DRV8825

Discussion in 'Bulldog Extruder' started by krwynn, May 23, 2015.

  1. krwynn

    krwynn New Member

    May 22, 2015
    Hello all,

    Trying to determine the proper voltage setting when using a 8825 stepper driver. For some reason finding a consensus calculation is proving difficult. Anyway I've come up with no more than 3 variations. The results of those were .30, .48 and .43 volts. Does anyone have a bulldog working with one of these stepper drivers, and if so, what do you use for your setting?


Share This Page