Welcome to aurora.com! Log in or Sign up to interact with the aurora community.

Bulldog XL & E3D6 mount

Discussion in 'Bulldog Extruder' started by Eloque, Nov 24, 2015.

  1. Eloque

    Eloque New Member

    Joined:
    Nov 24, 2015
    So I got a Bulldog XL, specifically to work with my new E3D v6, but so far it's been quite disappointing. The metal mount plate doesn't fit the E3D v6. There is about 2 mm worth of slack and there is no way to tighten the small bolt if the E3D heatsink is in place. The Bulldog XL is advertised as being E3D v6 compatible, so maybe I am not doing something right, but with the slack being as it is and no way to even screw down the mount I need another type of mount.

    I've been looking for the specs on the Bulldog XL mounting plate, so I could modify and print one on my current setup, but so far, all I found is the measurements on the extruder itself.
     

Share This Page