Welcome to aurora.com! Log in or Sign up to interact with the aurora community.

Full Graphic Smart Controller with RUMBA

Discussion in 'RUMBA' started by phd0, Jun 10, 2014.

  1. phd0

    phd0 New Member

    Joined:
    Mar 20, 2014
    Location:
    Lyon (France)
    Hello,
    when i connect my newFull Graphic Smart Controller to the Rumba, le back-screen blink, and the beeper too.
    I try to inverse the EXT1 and EXT2 : not better (but no blick)
    Yes i active the #define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER line in config.h
    and i try with the last MARLIN too. not better

    Is some one have test it before me ?
     
  2. Oyvind Amundsen

    Oyvind Amundsen Member

    Joined:
    Nov 23, 2013
    Location:
    Norway

    Attached Files:

  3. phd0

    phd0 New Member

    Joined:
    Mar 20, 2014
    Location:
    Lyon (France)
    thx, yes, i see the small tab, and i still analyze the scheme (rumba and screen) to understand where is the mistake

    Philippe (French)
     
  4. ProCoPrint3D

    ProCoPrint3D New Member

    Joined:
    Jun 19, 2014
    Location:
    BELGIA
    I works fine on 2 boards
     

    Attached Files:

  5. phd0

    phd0 New Member

    Joined:
    Mar 20, 2014
    Location:
    Lyon (France)
    thx, but it is not exactly the same a buy in DX.COM.
    I think this clone is not realy a good clone of the RRD official.
    Philippe
     
  6. Oyvind Amundsen

    Oyvind Amundsen Member

    Joined:
    Nov 23, 2013
    Location:
    Norway
    Have you installed U8glib?
    Does it compile ok in Arduino?


    From the WiKi:

    In "Configuration.h”
    1. Change “#define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER” (just remove the // at the beginning)
    ==> REMEMBER TO INSTALL U8glib to your ARDUINO library folder: http://code.google.com/p/u8glib/wiki/u8glib

    Upload the firmware, power off the Arduino, connect the panel, reapply power, and everything should work.
     
  7. ProCoPrint3D

    ProCoPrint3D New Member

    Joined:
    Jun 19, 2014
    Location:
    BELGIA
    Must be configured U8glib in Arduino
    option must be selected
    # define SDSUPPORT
    # define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER
    Whether the same or blue or without a button
     
  8. ProCoPrint3D

    ProCoPrint3D New Member

    Joined:
    Jun 19, 2014
    Location:
    BELGIA

    Attached Files:

  9. Tony

    Tony New Member

    Joined:
    Aug 8, 2016
    Hello,
    i know this is an old post but i got the same problem. With the firmware you, ProCoPrint3D, uploaded i got a louder beeping und the display still flashes.
    @phd0: did it work at your board and display?

    Thanks for your help.
     

Share This Page