Welcome to aurora.com! Log in or Sign up to interact with the aurora community.

Heated bed temperature just increasing

Discussion in 'Reprapdiscount aftersales Support' started by Ivano, May 20, 2013.

  1. Ivano

    Ivano New Member

    Joined:
    May 20, 2013
    I've finally started using the Rumba I got from the indiegogo promotion. It's really a good piece of hardware, and I'm very satisfied with it. I like especially the ease of connection and configuration.

    However, since a couple of prints, the heated bed temperature just increases, and the last time it reached more than 100°C! (I set it to 60°C, since I'm printing PLA).

    I didn't manage to reduce it using the pronterface command to disable it, and as soon as I give power, the temperature of the heated bed rises.
     

Share This Page