Welcome to aurora.com! Log in or Sign up to interact with the aurora community.

I think one of my hall sensors is bad

Discussion in 'RRD Hall Endstop' started by Allan, Feb 26, 2014.

  1. Allan

    Allan New Member

    Joined:
    Feb 26, 2014
    I have three sensors installed as end-stops in a 3DR delta printer. All of the sensors will trip when a magnet comes within range but one of the sensors doesn't appear to respond to trim pot adjustments. Can anybody suggest further diagnostics to determine if the one sensor in question is faulty?
     

Share This Page