Welcome to aurora.com! Log in or Sign up to interact with the aurora community.

Pins for ext3 ? (for servo output)

Discussion in 'RUMBA' started by YoTiro, Dec 30, 2013.

  1. YoTiro

    YoTiro New Member

    Joined:
    Dec 30, 2013
    Hello.
    I'm trying to setup the bed auto level on my rumba board. And need to connect a servo.

    But I cannot identify by the schematic which pin on ext3 could I use for a servo output and which "pin number" does it correspond to assing it on pins.h file.

    Thanks in advance
    Fernando
     
  2. YoTiro

    YoTiro New Member

    Joined:
    Dec 30, 2013

Share This Page