Welcome to aurora.com! Log in or Sign up to interact with the aurora community.

Repetier Host & Firmware

Discussion in 'RUMBA' started by Uri. F, Feb 22, 2013.

  1. Uri. F

    Uri. F New Member

    Joined:
    Feb 13, 2013
    Location:
    Israel
    Is anyone tried to run the Repetier Host & Firmware with the Rumba?
    Can you share success stories or problems?

    Thank you
     
  2. roygpa

    roygpa New Member

    Joined:
    Feb 20, 2013
    I am making some headway with it. Was having endstop issues, but it was just because I was not familiar with the "Always Check Endstop= True command.
     
  3. Uri. F

    Uri. F New Member

    Joined:
    Feb 13, 2013
    Location:
    Israel
    I'm trying to find the simplest solution and i like the idea that the host and firmware from the same "home".
    And it is always good idea to learn from other people :)
     
  4. David Rosendahl

    David Rosendahl New Member

    Joined:
    Jan 30, 2013
    I have been using both (Actually going to use repetier-server as well since I have a raspberry PI mounted inside my printer).
    Not any problem to setup at all. Repetier firmware supports both RUMBA and the reprapdiscount LCD/SD directly in the configuration.
     
  5. Uri. F

    Uri. F New Member

    Joined:
    Feb 13, 2013
    Location:
    Israel
    These are good news 4 me, as a newbie I want/need to learn a lot
    hopefully next week i'll connect and run the Rumba and motors 4 first test
     
  6. Marcos Mamede da Silva

    Marcos Mamede da Silva New Member

    Joined:
    Feb 12, 2013
    Hi,
    I've just installed the Repetier Firmware and Repetier Host for test only one motor (X), but it doesn't work yet. I connected a 12V 20A power supply, only one stepper driver, one nema17 and one end stop, but when I try to test it using Repetier host its just put the commands in a queue and nothing happen with the X motor. Somebody have had some problem like that ?
     
  7. Uri. F

    Uri. F New Member

    Joined:
    Feb 13, 2013
    Location:
    Israel
    i do
     
  8. Marcos Mamede da Silva

    Marcos Mamede da Silva New Member

    Joined:
    Feb 12, 2013
    I'm testing the motors and drivers yet, and to fix my latest problem I made some changes in configuration.h as below:

    #define MOTHERBOARD 80
    #define HAVE_HEATED_BED false
    #define HEATED_BED_SENSOR_TYPE 0
    #define ENDSTOP_PULLUP_X_MIN false
    #define ENDSTOP_PULLUP_Y_MIN false
    #define ENDSTOP_PULLUP_Z_MIN false
    #define ENDSTOP_PULLUP_X_MAX false
    #define ENDSTOP_PULLUP_Y_MAX false
    #define ENDSTOP_PULLUP_Z_MAX false

    #define BAUDRATE 57600 // Don't forget to put this value in repetier host baudrate too.

    #define EEPROM_MODE 0
    These changes are only to test if the stepper drivers and motors are working well, before connect all of motors into the printer frame,
     

Share This Page