Welcome to aurora.com! Log in or Sign up to interact with the aurora community.

RUMBA not using 12V power

Discussion in 'RUMBA' started by Sacha, Jun 28, 2013.

  1. Sacha

    Sacha New Member

    Joined:
    May 19, 2013
    Hi, I'm able to connect to and power my RUMBA via USB, but I can't power on the RUMBA with 12V - yes, I've changed the jumper to "stand alone."

    When I provide the board with 12V in the MAIN PWR terminals, the power light does not light up, and the smart controller does not power up.

    I have tested and the screw terminals do have 12V in the correct polarity.

    Any ideas what's going on or what to test?
     
  2. Sacha

    Sacha New Member

    Joined:
    May 19, 2013
    a quick update: I checked the fuses' continuity and they're both good
     
  3. davidkosir

    davidkosir New Member

    Joined:
    Dec 13, 2013
    We having same problem here, have you managed to find a solution?
    I've submitted a ticked but there was no answer...
     

Share This Page