Welcome to aurora.com! Log in or Sign up to interact with the aurora community.

Rumba temperature problem

Discussion in 'RUMBA' started by Yves, Feb 3, 2014.

  1. Yves

    Yves New Member

    Joined:
    Feb 18, 2013
    Hi all,

    Even if I disconnet the thermistor, temperature indicate 250°...
    i try reflash the firmware with no result.
    If someone have an idea ?
     
  2. 3machine

    3machine New Member

    Joined:
    Dec 19, 2013
    imo it doesn't work whitout any thermistor plugged (ERR:MAXTEMP) or a single wire (ERR:MINTEMP). it depends of the firmware.
     
  3. zumpitu

    zumpitu New Member

    Joined:
    Mar 23, 2014
    Hello ! I have the same problem !

    After 2 Day spended to connect the USB now I have this message "ERR:MAXTEMP" on the display and I can not do nothing from PC
     
  4. 3machine

    3machine New Member

    Joined:
    Dec 19, 2013
    recheck your thermistor
     
  5. zumpitu

    zumpitu New Member

    Joined:
    Mar 23, 2014
    thanks.. I did , but always the same problem, i did also a new firmware and is the same but now the display write 0°.. the pin conf was from the reprap wiki and again ERR:MAXTEMP
     
  6. zumpitu

    zumpitu New Member

    Joined:
    Mar 23, 2014
    :( No solution... I'm very disappoint, I will have to bay a new different card for my RepRap o_O
     

Share This Page