Welcome to aurora.com! Log in or Sign up to interact with the aurora community.

Rumba USB port broken

Discussion in 'RUMBA' started by Jkrott, Jan 15, 2015.

  1. Jkrott

    Jkrott New Member

    Joined:
    Jan 15, 2015
    I built a delta style 3rd printer, and while i had the USB cable plugged in, one of the carriages caught on the cable and snapped the USB port right off of the board! The solder pads are much too small for me to solder to so I am at a bit of a loss as what to do. Any suggestions?
     

Share This Page