Welcome to aurora.com! Log in or Sign up to interact with the aurora community.

The Rumba is dancing very well now

Discussion in 'RUMBA' started by Yves, May 13, 2013.

  1. Yves

    Yves New Member

    Feb 18, 2013
    I use this board in standalone on a mendelmax and it is very nice. You turn the knob and the speed increase while printing. It is a big plus. Only thing I havent found is how to retract some filament while the machine is home positioned ? Before to launch a print
    No more connection with the computer and that is much better. I use it to slice only.
    With a 24 V bed, it heat very quick (3mn to get 70°), and same for the hotend.
    Thanks to Reprapdiscount to furnish 24V Thermistance in the kit.
  2. BubbleRep

    BubbleRep Administrator Staff Member

    Nov 11, 2012
    there should be a point at the prepare submenu, i don't have the menu completely in my head but i think it's: prepare -> move axis -> extrude if you use the knob in minus direction == retract.

  3. Yves

    Yves New Member

    Feb 18, 2013
    Yes I check that a little after I post.
    It is a very good solution.

Share This Page