Welcome to aurora.com! Log in or Sign up to interact with the aurora community.

Thermistor and side Problem

Discussion in 'MK2B dual power heatbed' started by OfSalty, Nov 10, 2013.

  1. OfSalty

    OfSalty New Member

    Joined:
    Oct 28, 2013
    Hi,

    I just geht My mk2b dual heatbed. I read that i can Print Directory on the heatbed but on which side? Black or Aluminium? And where to put the thermalsensor?

    Wiki says that it Must put in the hole in the middle but then it will get the temperature of the molden pla?
     
    Hacik Ozdilian likes this.
  2. RepRapDiscount

    RepRapDiscount Administrator Staff Member

    Joined:
    Nov 13, 2012
    You must print on the aluminum side. The thermal sensor you have to apply from downside
     
    Hacik Ozdilian likes this.

Share This Page